Thanks Peeps, yes I think Brunel was pretty cool! They are pretty strong. I could get air lifted bout by them if need be. I have drilled them out a bit to save a few grams.....
Fitted them this eve.
Good idea John, all I can come up with is either wing nuts on the mounts or it would only be two nuts per side to split the hinges. I might weld up two of the bolts. Good idea!
[IMG]
[/IMG]
Chopped out the middle of the bonnet inner molding (sorry Chris) to get clearance over my suspension brace, but also to use sections if the molding to add new hinge mounts further out....[IMG]
[/IMG]
...
Tomorrow Ill glass those new bits, glassing over some 6mm plate to tap into.
[IMG]
[/IMG]