thanks. It is good to be here.... again
Mr T, funnily enough I went to Mike's on Saturday to pick up my frame, but while I was there, I asked if I could 'borrow' his welder to make some mods to it. If you remember from my Sammio build, my little mig welder kept cutting out and as my mum alwasy said - if you don't ask, you don't get!
I wanted to move the tank to the rear and put in a luggage space as that was really useful in the Sammio. The end result was that I left my frame there and Mike said he will use that to be the 'standard build' now
I quite like the idea of being the guinea pig if I can help influence the design to make it better for others in the longer run!
This is the "modified" frame...
2013-03-09 16.35.52a.jpg
When I got home I started putting the engine together....
New valves ground in....
2013-03-11 18.31.07a.jpg
2013-03-11 21.48.20a.jpg
Pistons in with new rings....
2013-03-11 21.48.05a.jpg
I am just waiting on the new thrust washers from Rimmers (i'm tightening up the end float from the standard 8-14 thou to around 3-4 thou) and then the crank can get put in and the engine closed up and built.