[raasayphil]

Hi

I have tried to pick up any old post on the problem that Patrick had on page 1 of his build diary where the rear spring bump stops do not align. Patrick wrote that he must contact Marlin for their thoughts.

I did so a few weeks ago and was told "The misalignment does seem to minimal. I would just give the threaded bar a knock in the right direction. If you have problems with this then give me a call."

Is this the same response Patrick got. I note that Patrick resolved his problem by using coilovers - but that is quite an expensive route especially as you only seem to be ablwe to but the as a complete set i.e fronts and rears.

Anyone any ideas? My alignment looks as good as Patricks did!!!

Thanks

Phil