Quote:
Originally Posted by Amir Manzoori
I am glad you liked the idea. But to be able to remove the bracket without having to take the body off the chassis, it will be a good idea to have the lower one in one piece but the top one cut in the middle and each half to have its own bolt to secure it to the one below.
|
You're right again....
Looking at this picture again, I certainly need to check the options with the body tub on, which was my next step...and I think I need to install the propshaft to check clearance.
Fuel/brake line planning by
marlinpeter, on Flickr
I think I spoke too soon as I think version 4 may be next.....
(that will be after I've fixed my daily drive that has sprung a leak from the HP diesel pump
)
cheers, Peter