Quote:
Originally Posted by SwiftyDS
I've just started to fit mine - using 24mm black Dzus fasteners as also decided to bolt clam down to start with (may hinge later). I've bonded / glasses a couple of angle brackets to clam so it can bolt to rear support bar from within engine bay so they are hidden.
For the screen itself I drilled a pilot hole first with 2mm drill at low speed (using a dremel) and then drilled it out with 6mm drill again at low speed. Halfway through the holes and touch wood all OK so far !
I've read conflicting views of whether to use sharp or used drill bit. Both bits were relatively new
|
I am getting the windscreen guy to bond mine in, he reckons it will be fine with just that, but mine can stay in place as the clam will lift.
Looking good Nick, thinners with get the fibreglass off your fingers afterwards
