Well getting with re assembly now. Got to make front tie bar with brackets for the anti twist tie bars to the chassis. Not too sure If I like the spire nuts on the outer pivots, but they 'hotrod' and that is the theme of peggy's rebuild. Got to make the radius rods, decided they are a requirement, going to be twin bar tapering to the front end bush. Then must get round to designing the mounting frame, hope to make it a bolt in job sitting inside the existing chassis frame, that will make it easier to drop out if I need to work on it at a later date.
Anyone got any views on my axle etc just go for it. positive or otherwise. Any knowledgeable ideas would also be useful.
http://s1342.photobucket.com/user/Ba...%20rebuild%202