Quote:
Originally Posted by 1iTim
Awesome, mas. In the foreground of pic 1 do i see fibreglass floors? Iff so pleasd can you tell me about them, especially if you have any engineering specs about them (strength etc) and cost (pm me if u like with cost etc)
Best,
Tim
|
Quote:
Originally Posted by redratbike
Jesus!!, bloody eagle eyes or what!!????
|
I actually forgot to mention about the floor pans, and unfortunately I can't find the email with the costs,
mikmiglia made them for me, as these are lower that the other set of steel pans I have from my Sammio/Ribble Pilot kit. So once I have the body in position, I will be test fitting both to see with fits me the best.
I am sure
mikmiglia will be able to help and advise on the costing's for the lower pans, these are GRP strengthen with plywood (but I can't remember the construction details).
This is the list of parts I purchased when I bought my kit.
Kit contents
•One piece Miglia Speedster body
•Bulkhead
•300mm deep dashboard blank moulded into body
•Tear drop vent bonnet
•Double skinned doors
•Perspex windscreen
•Windscreen frame
•Steel subframe
Extras
•Twin Humps
•Lower floors pans
•Chrome air vent rings
•Gearbox Linkage (is there a difference between non-OD and OD)
•Beer crate grille
Addition contents required to be supplied
•Rear Inner wheel arches (for rotoflex)
•Head rests untrimmed just the basic shape.
•Qty of GRP (matting, resins, release agent etc) to make a transmission tunnel and dashboard mods, also bonding materials required.