Saturday - Part 3:
The thickness of the paint made fitting the grommet for the number plate light wiring quite tricky.
I then ran into a small technical problem when I couldn't find the allen key for the bolts.
And I need to have this tightened up before I can fit the rear number plate over the top.
Still, at least I had already cleaned up the number plate before I realised I couldn't refit it.
So I fitted the rear fog lights instead.
Last job of the day was to crawl around under the boot floor to sand down the filler.
Not easy to get some decent photos, but you get the general idea.
There are also a few normal 'patches' on the boot floor that need a coat of Tetroseal too.
With a bit of luck I will be able to do that tomorrow, which will then allow me to refit the tail pipes and restart the engine.
Until next time, take care, Paul.
