Thread
:
Up-dating my McCoy
View Single Post
#
21
31st October 2015, 15:45
pompeyal
Senior Member
Enthusiast
Join Date: Jun 2008
Location: Fareham, Hants
Posts: 161
Exhaust (cont’d)
The next problem I incurred was a clash with the sub-frame cross member
so rather than spacing it out I dealt with that by making a new one and again called on the services of my welder
I also had a small issue with the clutch slave fouling the new cross member so I dealt with that as well while I was at it
Finally got the rear exhaust bracket to fit..
And I have a small issue with the lamder sensor clashing with the sub-frame and will need to deal with that before long
That’s nothing for a cutting disc
pompeyal
View Public Profile
Find all posts by pompeyal