View Single Post
Old 6th September 2020, 18:25
andysharrock's Avatar
andysharrock andysharrock is offline
Senior Member
Join Date: Jun 2011
Location: sheffield
Posts: 564
andysharrock is on a distinguished road

Not every day you plaster a car but I fingered it was going to be the essayist way to fill and smooth things out


I then covered everything in tin foil so touch wood 90% should come off without to much trouble

I used 300g csm then 3mm core mat two more 300 then topped just the middle with 600 csm hopefully it should give me enough strength. if not I will add more after I cut it back .


it should be thick enough to cut back around the windows I will then gel coat the lot. I will also fill in the inside of the A post and put a top on the B post


least I can make the B post on the bench and just glass it in,Most of it had set by the time I packed up I had to resist the temptation to cut the windows out and start removing the inner support.
Reply With Quote