Thread: CJ's Build
View Single Post
Old 14th November 2011, 22:08
garyh garyh is offline
Senior Member
Join Date: Jun 2011
Location: birchington, kent
Posts: 1,767
garyh is on a distinguished road
Default Thanks, Chris and Dave

I will learn to weld, then i will be confident... hows that. So, anyway where my new floorpans just run straight across with out stepping up could not just extend sides of bulkhead down to meet floorpans and weld a nut/washer on the inside of the pan and don't worry about the mounting points? as long as the body comes off the same way... and its all covered over in fibreglass.
Reply With Quote