Thread
:
volvo p1800 into ferrari 275gtb nart spyder: v12, 5spd, tube chassis
View Single Post
#
65
10th January 2018, 22:14
275NART
Senior Member
Join Date: Mar 2015
Location: South Carolina, USA
Posts: 116
The shaft already had a splined to 3/4"dd joint where it attached to the steering rack on the saturn. It was also the perfect length and that made it easy to connect to the stainless steering shaft material I purchased. I am going to anchor the section of steering shaft that runs parallel to the inside of the frame rail using a 3/4" heim joint. I will weld a threaded bung in the frame and the heim will thread in to that. It will also allow the steering shaft to be pushed off the frame rail a little bit as well. You can see there is some interference with the joint and the frame rail close to where it comes through the firewall.
275NART
View Public Profile
Visit 275NART's homepage!
Find all posts by 275NART