Door pics.
If your on face ache I can buzz you loads over messenger. Basically fast cut across the lower protruding line (it's on the skunt) . Door card off. Lower window and whip off mirror. Window up, whip handle and lock out. Sill trim and kick panel off. Unplug and feed out wiring. Check strap off and then the 12's for hinges. Flip door and remove seal. fast cut across the line that follows the seal. Bash panel to right angle, support later to help with new outer skin alignment. Cut about 3" across and from glass seal down the rear lip. Trim a bit more lower edge round the lock to clear sierra stuff. Inenner rear edge kinda follows seal line. Remount door and then try new skin. Won't be far off. Set it off the front edge
|