I bought some aluminium slots to fit the brake ducts when I was at Stoneleigh last year. I have been toying what to do with them. When I opened them up they turned out to be chrome. I had decide to fit the same stainless mesh behind them as is in the front bonnet aperture, I was going to route out a recess at the back to fit the mesh but can't now do that as the are chromed steel.
Plan B
I carefully trimmed the mesh to size and then stuck a 1.5mm gasket around the edge so it would all sit flush and was very pleased with the result
However I'm not sure if I like them on the car
Do they look a bit like a boy racer add on bought from Ebay?
I'm not keen on the bare slots as I think they make it look a bit unfinished