Sunday - Part 2:
Anyway, back to today's problems and I wanted to paint the inside of the side mirror mounting areas.
I'd previously left this unpainted because, at some point, I will make/fit a removable cover out of alloy sheet.
But for now, it was time for a coat of Tetroseal, after covering the mirror holes with tape.
Not a great photo and the 3rd "hole" is actually a reflection of the camera flash.
I also painted over the mess I had made on the passenger side cockpit wall.
Plus the control arms.
Before spending quite a bit of time crawling around under the boot floor with my paint brush.
And whilst it may not look it in the photo, the boot floor is now one colour again.
I just need to wash the dirt off some parts and give a second coat of Tetroseal to others and the floor will be done.
Then it was time to remove the centre section of the dash.
So I could spend ages fitting the rear view mirror in the tightest of tight spots.
Before refitting the dash section.
Next up were the side mirrors.
End of Part 2...