Quote:
Originally Posted by Mike
I am planning to extend the servo push rod (cut and weld insert) leaving the forked end to attach to directly to the pedal: this will leave a single pivot connection rather than the double one created by the adaptor. IThis has the double benefit of lining the pushrod with the servo centre line, and reducing the play in the overall pedal-servo connection.
Mike
|
I thought about this but it then means you have a non-standard servo which is not so good for spares. In fact the Marlin supplied adapter I have is machined (crudely) to accept the end of the fork so that you don't have two joints than can pivot.
If you are using the marlin adapter that fits between the servo and the master cylinder you may also need a little spacer that fits between the servo push rod and the mater cylinder. If you don't the pedal moves about halfway to the floor before anything happens! You can see some pictures on my website.
Robin