Got one of my new FOBCO drills set up tonight. Used it to tackle the problem I had with the threaded rods turning in the front hinge mechanism.
Clamped it up in the compound table that came with the drill which allowed me to dial in the positioning exactly, no more off centre holes for me :-)
Drilled a 2mm hole through the Ali boss and through the stainless threaded portion, didn't snap the drill and it drilled where I wanted it, have I mentioned how much I love my new drill?
Drifted in a 2mm Roll Pin
Trimmed the excess off and job done, repeated for the other side and now the last hiccup on the bonnet hinge is sorted, bonnet goes on for real tomorrow!
TTFN
Mac