View Single Post
  #4  
Old 24th May 2020, 11:09
NeilF355 NeilF355 is offline
Senior Member
 
Join Date: Sep 2011
Location: Teesdale
Posts: 238
NeilF355 is on a distinguished road
Default

Check that the wiring to the speed sensor is intact.

I had a problem with one of those Hall Effect sensors - the wire was touching the exhaust which had melted the insulation.
The speedo needle would not move until I reached about 40 - 50mph at which point it would jump up to the correct speed, then drop to zero if I slowed to below 40.
Reply With Quote