View Single Post
  #10  
Old 27th March 2021, 16:13
Mitchelkitman Mitchelkitman is offline
Senior Member
 
Join Date: Oct 2013
Location: norfolk
Posts: 691
Mitchelkitman is on a distinguished road
Default

One solution with wing stays (if they are breaking near a weld) is to braze joints rather than weld them - this has been used successfully on bicycles for over 100 years. I know some will say 'lugged joints', but there are also thousands of lugless frames out there as well - VERY thin tubes taking huge forces (think front forks, the ends are a simple brazed joint consisting of a plate in a slot!)
All to do with the heat affected zone....... when welding takes place the metal near the weld can be adversely affected by the heat, causing it to break - the heat of brazing is much lower.
Reply With Quote