View Single Post
  #6  
Old 17th October 2020, 18:42
cbjroms cbjroms is offline
Senior Member
 
Join Date: Jul 2011
Location: Hampshire
Posts: 146
cbjroms is on a distinguished road
Default

@Grey V8 Pete a belated thank you for the above advice and guidance.

I have changed the system so that the 25mm spout on the bottom of the expansion bottle is now connected by rubber hose to a T piece in the bottom radiator hose (as per pistonheads advice).

Rather than fit an air bleed into the top radiator hose or thermostat housing, I remembered that my initial plan had been to unbolt the radiator and lift it above the thermostat housing when filling the cooling system. This should allow any air trapped in thermostat housing to escape?
Reply With Quote