Quote:
Originally Posted by MartinClan
A question for Peter....
When fitting the "Lift the dot" fixings on your hood did you use the special tool - or did you improvise?
Robin
|
I tried to find someone with the tool to borrow but no luck.
I used a hollow ground hole punch for the holes (you get some pretty cheap sets off ebay) and then I sacrificed one of the fixings. If you put a block of wood behind and hit it with a small hammer the tabs will pierce the material. Use the end grain of the block of wood as its softer. Then replace with a new one and bend the tabs over with a pair of long nose pliers. A bit time consuming but quite easy once you get going. I've got some spare fixings if you need any extra.
...peter