Hi Ross, good to see you over here. It is also important the engine issue.
I use alfa 166 hubs because i´m using alfa 3.0 v6 engine from a 164, so the driveshafts also match with 166 hubs.
However, you may even have other option for the hubs, with bigger centre bore, and still fitting cromodora wheels, because the wheel accepts a larger diameter hub, fitted behind the hub cap hole, where there´s a larger than 58mm diameter. No need for machining the wheel. I actually ended up doing this and goes fine. This also could allow you to use a different engine/driveshaft combination...
How is your project going so far?
regards
Dino_GT
|