Sunday Service:
After the morning fog had finally cleared, I cut out another section of left over fibreglass.
Which will form part of the join between the boot floor and the body shell here.
( Passenger side. )
Note:
At this point I just want to ensure the rear passenger corner is supported/held in place.
Then mixed up some more bonding paste and tackled a number of small jobs.
Fitted the plywood panels inside the boot.
Fitted the panels between the boot floor and the rear body shell at the back.
Not great photos, but added paste where the boot lid rain channel meets the framework.
And finally the section I had cut out earlier.
Boy was this messy work and not helped by the need to crawl around on my back to reach some of these areas.
The only other thing I had time for today was to add more fibreglass matting to all three "bridges" on the driver's side.
I will be adding at least one more layer of matting along all the joins at some point, but it already feels very strong.
Until next time, take care, Paul.
