Thursday - Part 2:
I finally got around to putting some thick cardboard in front of my new radiator.
Hopefully this will help prevent any accidental damage during construction.
Even though I will not be connecting this up just yet, I did fit the cut off switch.
The restricted access at the back made this much harder to do than it should have been.
For now, I've just put the switch cover in place until the wooden dash board section gets fitted.
I made a small funnel to get some 3-in-1 oil all the way through the throttle cable.
Then the cable fitted through the bulkhead and connected to the accelerator pedal.
I was then able to fit the new pivot pin parts at the other end.
( Replacing the original parts that were lost/missing. )
Overall, lots of small jobs, but it does feel like I am finally working my way towards the "Moon Buggy" stage.
So until next time, take care, Paul.
