Quote:
Originally Posted by IanA
Super job and quick too.
I like the seats- low back with detachable headrests. How are the seat-belts mounted? Did you keep the Z3 sub-frames?
|
Good afternoon Ian , i did not use the Z3 sub-frames , i bought the seats with a set of runners for each and then used a piece of 2"square hollow steel to run from side to side of the runners , this steel was then bolted into the standard Z3 floor mounting points , the seat belt on the right hand side of the drivers seat was bolted down to the floor , the seat-belt stalk on the left hand side of the drivers seat was bolted to the steel that runs from side to side , hope this helps Geoff .