This week I've finally re-fitted the gearbox tunnel
As mentioned above, before the final fitting, I swapped to a different gearstick which has a shorter throw. I also fitted the cabling for the reverse light switch and drilled some access holes to be able to do maintenance on the reverse light switch and the speedo sensor.
Reverse Light switch by
Sabrebuilder, on Flickr
To seal the tunnel I used this non-setting mastic.....
Tunnel sealant by
Sabrebuilder, on Flickr
And finally, the least exciting photos.....
Gearbox tunnel by
Sabrebuilder, on Flickr
Gearbox tunnel by
Sabrebuilder, on Flickr
The gap between the gearbox and the propshaft tunnels will be filled with a removable fillet.
Not the most exciting update but an important milestone as it means I can now move on to installing the electrical looms
....peter