Removed the brace bar this morning cut some end boxing pieces , bonded and glassed them into place ..after a trim , some latch fitting holes drilled etc. and a quick sand , the underneath of the bonnet can be flowcoated to make it a nice uniform finish
gif free upload
I also re-instated the exhaust that was removed , cleaned up and painted satin black ... and put some fixings in to hold the body on ...
As a footnote ..the bulkhead panels that I have templated are going to be available in aluminium as a full panel with swaige lines pressed in , very similar to the bulkhead on Graham's car , they will be supplied in 2 halves with a joddled edge on one panel allowing the other one to lap onto it nice and flush and a single row of rivets can join the 2 together ... ....prices to be confirmed .....