View Single Post
Old 20th August 2021, 13:03
Jaguartvr's Avatar
Jaguartvr Jaguartvr is offline
Senior Member
Join Date: Jan 2014
Location: Egham, Surrey
Posts: 1,752
Jaguartvr is on a distinguished road

A few pictures of the loosley positioned dahboard, it needs to be leather covered.
The dash is partly held in position by the front of the heater cover panel. This extends to the floor on both sides and up to the front bulkhead which makes it all very stable. It also allows you to fit the existing heater controls. The existing rotary controls are a tad short so I 3d printed some which worked but the finish wasn't great so I am working on some alloy ones.
I have had made an alloy plinth to take the smaller instruments, apart from looking good the advantage is that you can fit the instruments to the plinth first and then install the plinth into the dash assembly in one go, much easier.
Trimming the inside of the alloy plinth with leather proved to be an absolute pain so I had an insert 3d printed, this way you stick the leather to the insert and then trim it, much easier and then the insert is held in by the instruments. I had to make the insert in 2 halves due to the size of my printer.
I haven't gone into details about removing the dash as I did it ages ago and have forgotten most of it, I have however just been reminded that there are 2 hidden allen screws that are hare to spot and a pain to remove.
Reply With Quote