I think Chris's Z3gt dash would look good in a Kobra. One of the reasons these instruments are so expensive is the style, they need printing on the glass and separate sections inside. Kobra clocks would be so much easier to make, as Grassbank has already done the hard work on the 250 dials the cost of producing the Kobra dials would be far less. A few 3d printed cups, glass and dials along with the same loom.
Or you could use the ETB instruments which will now be much easier to fit as we have the full (and idiot-proof) wiring diagrams. This would probably be the cheaper option and would give you working oil pressure/temperature and volt gauges.
It would be nice to see full interior done on a Kobra, I don't think one has been done yet.
|