It has been quite some time since I updated. I have been working on translating a 3d model into a real physical structure and all is going well so far.
I ended up shortening the sides approximately 2" for the wheelbase to match the body as well as massaging the rear quarters to look closer to photos.* Visually it looks correct after a quick photoshop job too.* I have to just assume the 3d model I have been working with*was a tad out of scale.* Unfortunately*the 3d printed parts are quite fragile and I need to reinforce the insides before I crack any more pieces off...* After that I can begin hard mounting everything on the chassis.* The plan is to have it all be bolt on*for ease of removal as needed for working on specific sections.*
