Small Jobs Against The Clock - Part 2
Just before I but the arches on I checked how this cover plate fitted.
Because I need to modify it so that it will fit over the longer studs fitted to the lowering block.
Next I re-fitted the twin tail pipes.
I just needed to remember to allow enough room so that they do not foul the chassis.
( Not a great photo. )
Then I could mark up where the support bracket met the floor.
And drill pilot holes in the floor in preparation for starting to make the supporting brace.
Then it was another mad dash to put everything again.
And with just the rear framework off the chassis, the drive has been tidied up too.
Thankfully the rain finally arrived while I was typing this up.
Right, got to go, Paul.
