Quote:
Originally Posted by 1iTim
Its been a while (hols in NZ, easter etc etc) but i have the swing spring and disc kit and am industriously putting things together. can't upload pics at work though
sadly I broke a rear trunnion bush jamming it on with no lube, lesson learned for the fronts, and antiseize liberally on the bolts that go in there this time. when the replacement turns up i will get the rear axles back on the car, and my freelander studs will be here soon (thanks auskellian) and that will mean the rears can be completed!
the secondhand front hubs from rimmer required a bit of cleaning up thats for sure, but they are ready for their bearings now. I used bearing housing loctite 641 (or 642 i cant remember) which worked a treat on the rears- probly use on the fronts too.
I'm not going to worry about ride height until i get the frame on and weigh the body and sandbag simulate it, then sort out the size of rear lowering block i need.
I am worried about the stiffness of that rear spring - anyone with knowledge/experience there?
|
I built a Triumph based Marlin Roadster many years ago. Donor was a Spitfire. Using a brand new spring I had to remove one of the leaves to get the ride correct. If you leave all of the leaves in and just use a spacer block to adjust the height I guess that the ride will be a bit on the hard side...
Robin