Spent today tidying up a few loose ends prior to bonding the body on tomorrow (hopefully!). Fitted the tank for the water/methanol injection system, boxed in the gap above the new central seat belt mounts and cut the hole for the fuel filler neck to fit through.
Then spent ten minutes trial fitting the lights and number plates with sticky tape -
As you can see, it's a bit of a departure from the usual bee hive lenses. The red ovals are reflectors, the white ones are indicators (actually intended as side repeaters) and for safety reasons there are twin rows of led's either side of the number plate light to give much brighter illumination of the brakes and rear marker lights than with conventional bulbs. I'm quite pleased with the look.
