Thread: Updates!
View Single Post
  #47  
Old 11th September 2016, 08:47
Patrick's Avatar
Patrick Patrick is online now
Senior Member
Enthusiast
 
Join Date: Feb 2005
Location: Hampshire
Posts: 2,468
Patrick is on a distinguished road
Default

3D printing does take ages, especially with 100% fill, 10 hours in, 18 to go. With less fill it would print much faster, but then it would be a weaker piece (the yellow on the print bed is Kapton tape - printing this stuff to the glass will cause the glass to chip):

Reply With Quote