Thread
:
Andreas Mx250 Coupe build
View Single Post
#
5
11th February 2014, 19:39
slangenracing
Senior Member
Join Date: Feb 2014
Location: Sweden
Posts: 140
Thanks "Fatbloke". I bet your well wishes will be needed! Started out with the rear wheelopenings after almost an hour in phone with the "car inspection" here in sweden, and Believe it or not, i could remove the rear wheelarches if i welded the inner fender to the outer fender. Also found a lot of corosion in the arches where they reach to the sills, and a bit of those were rusty too. But sheet-metel is cheap, and after a bit of work it was done!
Cheers!
New metal...
2K Primer on
Can probably take a low chassie and big Wheels
Last edited by slangenracing; 12th February 2014 at
08:08
..
slangenracing
View Public Profile
Find all posts by slangenracing