View Single Post
Old 15th July 2019, 21:47
306craig 306craig is offline
Senior Member
Join Date: Feb 2016
Posts: 272
306craig is on a distinguished road

Originally Posted by Paul L View Post
If it helps, I had no idea what I was doing when I took an angle grinder to my car.

Not sure you've seen SeaNick's MX250 build thread?

He did a LOT of fibreglass modifications and these included filling in the front three vents.

The thread is here:

And the vents start getting sealed in from Page 7.

Good luck, Paul.

Thanks for the pointer Paul. Had a good look at SeaNicks thread. I think getting rid of the 3 vents is within my grasp, however was thinking about going about a different way. Was thinking of basically cutting them out, fibreglass matt across the back (probably with a few bits of steel / ally in there for strength) then chopped strand from the front.
Reply With Quote