[JoeB]

It all started off as a 2.8 manual Z3 that I found on autotrader which was suitable.



Here are a few photos of when I first got the kit from nubodi and started placing the kit on the car.









The day I collected the kit was the day my new steering wheel arrived in the post too!



All it needed then was a piece of aluminium, a wheel centre cap and an hour or two on the lathe until it was ready to go in the car.





Once the panels were placed on the car I then went about deciding how I wanted the rear lights to be arranged and I also started mocking up how the exhaust would sit.







The exhaust is from a 2015 BMW M4 that had a small amount of damage to one of the tips. I will be changing the tips so this doesn't really matter to me.

The M4 exhaust has bypass valves built in so hopefully I can get these working with the car at some point in the future.