View Single Post
  #44  
Old 2nd February 2021, 12:27
Lucky@LeMans Lucky@LeMans is offline
Senior Member
 
Join Date: Aug 2012
Posts: 1,790
Lucky@LeMans is on a distinguished road
Default

Nothing major, just a clearance issue with the clutch cover fouling some webs on the inside of the bell housing. Two minutes with angle grinder to trim the webs down a few mm. I needed to tweak the release arm to find a few mm behind it to give some clearance at the front for the release bearing. They don't tell you that when you buy the adaptor plate, " it all simply just ", bolts together !
Reply With Quote