Not made huge progress over the last couple of weeks but have spent a fair amount of time working out the locations for the fuel pump and filters plus the routes for the fuel and brake lines.
The previous builder had managed to crush the fuel lines between the body tub and the chassis so I have planned some routes that will hopefully avoid the same issue.
Fuel/brake line planning by
marlinpeter, on Flickr
Fuel/brake line routing by
marlinpeter, on Flickr
I've also now trial fitted the fuel tank so I can start installation of the fuel lines.....
Fuel tank - trial fitting by
marlinpeter, on Flickr
I've also been buying up more parts from ebay.....
A high flow rate 100 micron fuel pre-filter.
High flow fuel pre filter by
marlinpeter, on Flickr
A 80mm diameter 180 degree silicone bend for the air inlet.
Air inlet bend by
marlinpeter, on Flickr
and another pedal box. This one is from an e87 BMW116 that has less offset on the brake pedal compared to the e36 and e46 pedals. Haven't had time to try it properly yet as the body tub is off at present.
BMW 1 (e87?) series pedal box by
marlinpeter, on Flickr
And finally, started making up another bracket, this time to mount the air input filter....
Air box mounting bracket by
marlinpeter, on Flickr
Next job is to start the fuel lines and mounting the fuel pump,etc...
...peter