Quote:
Originally Posted by Paul L
If it helps, I had no idea what I was doing when I took an angle grinder to my car.
Not sure you've seen SeaNick's MX250 build thread?
He did a LOT of fibreglass modifications and these included filling in the front three vents.
The thread is here:
http://www.madabout-kitcars.com/foru...ead.php?t=3924
And the vents start getting sealed in from Page 7.
Good luck, Paul.
|
Thanks for the pointer Paul. Had a good look at SeaNicks thread. I think getting rid of the 3 vents is within my grasp, however was thinking about going about a different way. Was thinking of basically cutting them out, fibreglass matt across the back (probably with a few bits of steel / ally in there for strength) then chopped strand from the front.