Thread: CJ's Build
View Single Post
Old 27th December 2011, 20:10
davecymru's Avatar
davecymru davecymru is offline
Senior Member
Join Date: May 2011
Location: Somerset
Posts: 1,671
davecymru is on a distinguished road

hummmmm, i'd not heard that one about chopping the front end metalwork before?

i'd got Gary to cut me my original floor pans and i certainly didn't chop any metalwork off the front and mine ended up ok. i admit that it doesn't lip under at the front as it's a bit high due to bulkhead/chassis rail differences (LONG story!), but even if i had the front lower and lipping over, i'm sure i would be fine?

I'll have a look tomorrow and see what the clearances on mine are like as you've got me thinking now!
Reply With Quote