Thread: vortex spec's
View Single Post
Old 1st October 2017, 05:57
GttNz GttNz is offline
Junior Member
Join Date: Feb 2014
Posts: 10
GttNz is on a distinguished road
Default vortex spec's

Hi Ian,

I'm currently nearing (I hope) then end of a GTT build. The only figure I have is front & rear track is 1592mm. Unfortunately my car is away at the trimmers so can't measure anything for you at the moment - maybe someone else can.

Yes the chassis is still being produced, Chris @Vortex could update you.

Alternatively a little while back there was an unfinished build at the rolling chassis stage that someone was selling - I can find out if it's still available if you think it might be of interest.

As far as other build details, have a browse of their website if you haven't already :

My engine/gearbox is from a Ford Focus 2.0 Ecoboost. Brakes are Rover/Granada, getting harder to source but I believe aftermarket may now be an option. There's also electric too.

Good luck with your build - a Dino was another I was tempted by.

Reply With Quote