Not a lot of progress at the moment I have finished the lower bulkhead panels and made the upper one's
[IMG]
[/IMG]
I have also made one of the side panels
[IMG]
[/IMG]
Then my faithful sheet metal cutter of 15 years rolled over and died on me
but then I managed to phone a friend and borrowed one
[IMG]
[/IMG]
So all is well again I can't decide weather to use the glass fibre rear panel supplied or make an alloy one both have issues I have also started labelling the wiring loom connections.
[IMG]
[/IMG]
[IMG]
[/IMG]