I collected the body and bonnet from Gary and Mike last Thursday. Had to just put it onto the frame to see what it looks like. Some photos here - very pleased with the look of the twin headrests.
Show5.jpg
Show4.jpg
Comparing photos on the Sammio website with those of other builders on this forum I was not sure how far the plywood floors should extend outboard of the side rails.
If I have understood Gary correctly, the floor should be in line with the side rails at the back but meet the bulkhead pressing about 1" in at the front. I have added a red line to the following photos of my current floor to show how, I believe, it needs to be trimmed back
Show1.jpg
Show2.jpg
Am I going in the right direction on this?
Thanks
Chris