Tuesday - Part 2:
When the first bolt went in without any problems I felt a small wave of joy sweep over me.
Unfortunately, I then could not manage to get any of the other three to go in at all.
At this point, my stiff upper lip may have experienced a slight tremble.
But I had another go at lining up the seat from above and this time all bolts went straight in.
This joy was short lived when I realised the top seat belt mount had slipped and was now facing down.
It took a significant amount of brute force and ignorance to get the fixing bracket the right way up.
But eventually the driver's seat was in.
For the passenger seat, I just needed to clean up a patch on the rear of the seat.
This time I taped the top seat belt bracket in the upright position.
This seat went in even quicker and so now both seats are in.
While I still can't find my big bag of screws, I did find four to complete the rear access panel.
It then gave me great pleasure to climb into the seat and start the engine.
But I just need to sort out the boot and my tool bag before I go for a drive.
Until then, take care, Paul.
