http://www.madabout-kitcars.com/foru...?t=5892&page=5
post 96
This was with the first version of the Tribute door skin, the later versions don't have the mark on them. You will however be able to work the position out from the photo.
I would make the hole larger as it is easier. Just attach a small metal plate to the bar seen inside the hole. Use a pilot drill and then tec screws. The plunger from the door handle simply presses on the plate to open the door.
A word of warning, make sure the plunger on the Mini door handle does not touch the plate, if it does it will cause the doors to occasionally and without warning deadlock. It the plunger is too far away then the door won't open. You must be very accurate, good luck.