The mutant Z300 shell has been laid up for a number of weeks now.
I have been collecting bits and pieces that I hope will be useful in its transformation.
My first job was to mock up a damaged rear end.
Out came the angle grinder
So after a bit of wandering around and looking at it from many angles, I think we have the start of something. I still have much musing of where to locate the twin TVR exhaust cans. But the number plate will fit above the rear diffuser.
The rear light cups have a limited area that they can be cut into. Legalities and the curvature to be considered.
The front wasn't safe from the angle grinder either. Chris showed his skill lopping off the Z300 nose. In one cut I could see how the previous idea for the Zagato would have formed.
The idea for the vent has been cut but to be honest I wasn't sure about it and its very close to the slam panel so I don't think it will feature in the finished car