Well there has been a lot of progress over the past week but not much to show for it!
The front of the shell has now been glassed to the end of the front outriggers and the rear of the shell glassed to the ends of the rear outriggers.
This makes things a _lot_ more solid!
I've also finished glassing between the bulkhead and the shell and reminded myself that i really don't like fibreglassing upside down and/or in awkward places!
I also put a skim of bonding paste over the fibreglass that runs along the bottom edge of the shell just to make it a bit more solid, even though i will be bonding and riveting alloy sheet to supply the eventual strength in that area.
Then i started shaping the doors and bonnet and i added a new reenforcing strip along the front edge of the bonnet.
The Blue foam packing from the edges of the alloy sheet i had delivered was the ideal size!
This is an awful photo, but gives you an idea of where it's gone.
Then the door locks turned up!
I've opted for the Mini Bear Claw latches from CBS and from an initial rough trial fitting last night they look and fit superbly!
I'll try and get some better photos of what's been done on the weekend