View Single Post
  #2  
Old 2nd June 2013, 00:55
MadDogMoggy's Avatar
MadDogMoggy MadDogMoggy is offline
Senior Member
Enthusiast
 
Join Date: Feb 2008
Location: Dorset
Posts: 107
MadDogMoggy is on a distinguished road
Default

Whilst monitoring the data on the K-Pro software today, initially I was getting no errors and a primary O2 voltage of between 0.01 to 0.2 volts, fluctuating quite a lot. The current was reading as -20 to -35 mA (yes minus!)

Later I was getting Heater errors, but the current was positive (I think) and the voltage about 1.4v

Anyone know what the correct readings should be? Initial thoughts are it could be the sensor, (or the wiring) and I was wondering what readings I should be getting!
Reply With Quote