View Single Post
Old 3rd September 2019, 12:00
deni deni is offline
Senior Member
Join Date: Jun 2015
Posts: 211
deni is on a distinguished road

Another thing I'd like to check - my clutch slave cylinder is fitted with a plastic pipe instead of copper one, so the connector attached to the slave cylinder does not have a nut/bolt thread.




I am planning to use a new flexible hose in between master and slave cylinder copper pipes using a rubber break hose.

Am I right in thinking that I can remove (unscrew) the plastic pipe connector from the slave cylinder and screw a new (short) flared copper pipe with the fitting directly into the slave cylinder?



So much for now.

Cheers, D.
Reply With Quote